New pump, stripped a hole in the block that holds the gear to the block (one of the lower bolts) I reassembled the pump hit the switch and the front only flinched. Hit it a few times just to get it to lift a couple inches. Held the pressure while it was there. Pump was out to replace seal between gear and block. Also was told to run 20-50wt oil in it so I changed that out as well. Was working just yesterday before I blew that seal and I'm already frustrated with this thing lol. Any help/ideas?
Basically my guess is that the gear is not fully seated to the block, maybe could slide a piece of paper between the two towards the bottom of the gear. Would this cause the car to not lift like this or could it be something else? If more info is needed let me know.
Basically my guess is that the gear is not fully seated to the block, maybe could slide a piece of paper between the two towards the bottom of the gear. Would this cause the car to not lift like this or could it be something else? If more info is needed let me know.